Key In Ignition; Locating Your Vehicle; Changing The Battery Of The Remote Control - PEUGEOT 206 Manual

THE KEYS
The keys allow you to switch on the
ignition and operate the passenger
air bag disarming switch and the fuel
filler cap, as well as independently
operate the locks on the front doors.
Central locking
The keys allow you to lock or unlock
the doors and tailgate from the front
doors.
If one of the doors, the tailgate
(206 SW) or the rear
(206 SW) is open, the central locking
does not work.
The remote control
This performs the same functions as
the key, at a distance.
26-05-2003
YOUR 206 IN DETAIL
Locking
Press button A to lock the vehicle.
This is confirmed by fixed lighting of
the direction indicators for approxi-
mately two seconds.
Unlocking
Press button B to unlock the vehicle.
This is confirmed by the rapid
flashing of the direction indicators.
206 SW: Press and hold button B to
unlock the vehicle and open the rear
screen.
Note: If the vehicle is locked and
unlocking is activated inadvertently,
unless the doors are opened within
30 seconds, the vehicle will lock
automatically (206 SW).
Avoid pressing the buttons of your
remote control out of range of your
vehicle. You risk causing it not to
work and the remote control would
then have to be reprogrammed.
screen

Key in ignition

A buzzer sounds on opening the dri-
ver's door, if the key has been left in
the ignition.

Locating your vehicle

To locate your vehicle, if you have
locked it, in a car park:
press button A. The courtesy
lights come on and the direction
indicators flash for a few seconds.
Changing the battery of
the remote control
Warning that the battery is flat is
given by an audible signal accompa-
nied by the message ''Remote con-
trol battery low'' on the multi-func-
tion display.
To replace the battery, remove the
screw then unclip the casing using a
coin at the ring (CR 2016/3 volt bat-
tery).
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Programming the remote
control
Switch off the ignition.
Switch the ignition on again.
Press button A immediately.
Switch off the ignition and remove
the remote control key from the
ignition lock. The remote control
is now working again.
87