When Removing Or Replacing Parts; Protecting Against Electrostatic Discharge - Dell Inspiron 4100 Solution Manual

2H767bk0.book Page 17 Friday, September 28, 2001 1:37 PM

When Removing or Replacing Parts

Before removing or installing memory modules, or adding a modem or Mini
PCI card, perform the following steps in the sequence indicated.
NOTICE:
when you are installing memory modules, or adding a modem or Mini PCI
card.
NOTICE:
a peripheral device or removing a memory module to help prevent possible
damage to the system board.
Turn off your computer and any attached peripherals.
1
Disconnect your computer and peripherals from electrical outlets to
2
reduce the potential for personal injury or shock. Also, disconnect any
telephone or telecommunication lines from the computer.
Remove the main battery from the battery bay and, if necessary, the
3
secondary battery from the module bay.
Ground yourself by touching the unpainted metal surface of the I/O
4
panel on the back of the computer.
While you work, periodically touch the I/O panel to dissipate any
static electricity that might harm internal components.

Protecting Against Electrostatic Discharge

Static electricity can harm electronic components inside your computer. To
prevent static damage, discharge static electricity from your body before you
touch any of your computer's electronic components, such as a memory
module. You can do so by touching an unpainted metal surface on the
computer's I/O panel.
As you continue to work inside the computer, periodically touch an I/O
connector to remove any static charge your body may have accumulated.
Downloaded from www.Manualslib.com
The only time you should ever access the inside of your computer is
Wait 5 seconds after turning off the computer before disconnecting
manuals search engine
Sa f e t y an d EM C I ns t r uc t i o ns : Po r t abl e C o m pu t e r s 17