Install The Indoor Unit - Vivax ACP-07CIFM21GEEI User Manual

Install indoor unit
The piping can be lead out from right, right rear,
●
left, left rear.
1. When routing the piping and wiring from the left
or right side of indoor unit, cut off the tailings
from the chassis in necessary (shown in Fig.2)
(1).Cut off the tailings 1 when routing the wiring only;
(2).Cut off the tailings 1 and tailings 2 when routing
both the wiring and piping. (or 1,2,3);
Take out the piping from body case, wrap the piping
2.
electric wire, water pipe with tape and put them th-
rough the piping hole (As shown in Fig. 3)
.
3 Hang the mounting slots of the indoor unit on the
upper tabs of the rear panel and check if it is firm
enough. (As shown in Fig.4)
1. Align the center of the piping flare with the relevant valve.
2. Screw in the flare nut by hand and then tighten the nut with
spanner and torque wrench refer to the following.
Tightening torque table:
Hex nut diameter
Ф6
Ф 9.52
Ф 12
Ф 16
Ф 19
NOTE: Firstly connect the connection pipe to indoor unit, then to outdoor unit; pay attention
to the piping bending, do not damage the connection pipe; the joint nut couldn't tighten too
much, otherwise it may cause leakage.

Install the indoor unit

Install the connection pipe
Tightening torque (N·m)
15～20
31～35
50～55
60～65
70～75
24
Gas side piping
Tailing 3
Tailing 2
Tailing1 Gas side piping
insulation
Fig.2
Finally wrap it
with tape
Right
Left rear
Right rear
Fixing hook
Mounting
board
Fig.4
Indoor unit piping
Spanner
External connection
electric wire
Liquid side
piping
Liquid side
piping
insulation
Water drainage pipe
Fig.3
Left
Mounting
board
Taper nut Piping
Torque wrench