Philips SC1982 User Manual page 30

EngliSh
30
No light pulse is emitted when I press the
pulse button
- Make sure that the yellow READY light is blinking.
- Make sure that you have good skin contact and
that the skin contact surface is evenly and firmly
pressed onto the skin. For your safety, the pulse
button will only activate a pulse if the skin contact
surface is in full contact with the skin.
- Check if the skin color warning light blinks orange.
If it does, the skin color sensor has stopped the
emission of a pulse. Your skin may be too dark to
use Philips Lumea Comfort. Try using the device
on a different part of your body.
- If the READY light is on constantly together with
any number of other lights, there is a system error.
Turn off the device and unplug it. Then plug in the
device and try to turn it on again. If the problem
persists, please visit www.philips.com/support or
call 1-800-243-7884 for assistance.
- Check if the system warning light is on and all
other lights are blinking. If so, unplug the device.
The device has reached the end of its life. Please
refer to chapter 'Disposal' for instructions on how
to dispose of the device.
- do not attempt to open or repair your
Philips Lumea Comfort. Always have the
device repaired by an authorized Philips
repair center.
- Do not attempt to open or repair Philips Lumea
Comfort. Opening the device may expose you to
dangerous electrical components and to intense
light, either of which may cause bodily damage
and/or eye injury.