Reversing The Door Swing - GE 22 Owner's Manual And Installation Instructions

Preparing to install the refrigerator.
Read these instructions completely and carefully.
Stabilizing Brake
This refrigerator is equipped with leveling feet
which serve as a stabilizing brake. These additional
leveling feet will hold the refrigerator securely in
position during operation and cleaning.
To set the brake, first remove the end caps and
base grille. Second, adjust the rollers to the desired
position. See Rollers. Then turn both leveling feet
on each side until the feet are firmly in place
against the floor.
On models with a freezer drawer: After the brake is
securely in place, unscrew the roller adjustment
bolt counterclockwise until the weight of the
refrigerator is supported by the stabilizing brake.
This allows the weight to be positioned on the
stabilizing brake.
Replace the base grille and reinstall the end caps.
Reverse the procedure to roll the refrigerator out.
Removing the doors.
The doors may need to be removed to move the unit through tight spaces.
You may also want to reverse the door swing for easier access to the refrigerator.

Reversing the door swing.

Read these instructions completely and carefully.
Before You Begin
When reversing the door swing:
I
Read the instructions all the way through before starting.
I
Handle parts carefully to avoid scratching paint.
I
Set screws down by their related parts to avoid using them in the wrong places.
I
Provide a non-scratching work surface for the doors.
IMPORTANT: Once you begin, do not move the cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from the right side to the left side—if you ever want to change the hinges
back to the right side, follow these same instructions and reverse all references to left and right.
Tools Required
I
Phillips screwdriver
I
Blade-type screwdriver or putty knife
I
Masking tape
12
Roller Adjustment Screw
(3/8" hex with slot)
Roller
Leveling Foot
CAUTION: To avoid possible personal injury or property
damage, the leveling feet must be firmly touching
the floor.
I
5/16" hex head driver
I
3/8" hex head driver
End Cap