Oki OkiLAN 6120e User Manual page 103

Section 4 - Chapter 2 - Configuring the OkiLAN 6120e
Gleaning
If an IP address has not been permanently assigned
when the OkiLAN 6120e is powered on or reset, it will
look for a ping packet on the network. If the OkiLAN
6120e receives a ping packet within two minutes, it will
accept the IP address in the ping packet as its own
address.
To use Gleaning, you must have Windows 95/98,
Windows NT/2000, or super-user privileges on a UNIX
system.
1. Add an entry in the ARP table that assigns an IP
address to the hardware address of the OkiLAN
6120e. To do this, use the arp command.
arp -s <ip_address><hardware_address> temp
UNIX Example:
arp -s 192.168.42.24 00:02:16:00:00:01 temp
Windows 95/98, Windows NT/2000 Example:
arp -s 192.168.42.24 00-02-16-00-00-01
2. Start a continuous ping to the OkiLAN 6120e.
ping <ip_address>
Example: ping 192.168.42.24
On some systems, this may require an additional
parameter. Some implementations of ping only send
out one ping packet which could get lost in transit.
Check your system documentation for more
information.
3. Connect power to the OkiLAN 6120e.
The OkiLAN 6120e will glean its IP address from
the ping packet. This IP address will remain in effect
until the OkiLAN 6120e is powered off or reset.
Therefore, a permanent IP address should be
assigned by running the OkiNet for TCP/IP utility or
via telnet.
Note: Gleaning does not work with Windows NT
Workstation 3.5.
OKI OkiLAN 6120e User's Guide IV - 9