Philips Avent SCH540 User Manual page 14

EngliSH
14
Note: Be careful not to bend the tip of the measurement probe.
 Clean the thermometer measurement unit with a soft damp cloth.
Do not immerse the measurement unit in water.
Do not sterilise or boil the measurement unit.
Do not clean the measurement unit in the dishwasher, in
the microwave or in a microwave steriliser.
4 Sterilise or boil the soother and protection cap (not the
measurement unit!).
The soother and cover are suitable for all forms of sterilisation.
Sterilise using an AVENT Steam Steriliser or boil in water for 5 minutes.
Do not use abrasive cleaning agents or anti-bacterial cleaners. Excessive
concentration of detergents may eventually cause plastic components to
crack. Should this occur, replace immediately.
If you use a sterilising solution, follow the instructions on the package. Do
not leave the soother in the sterilising solution for longer than
recommended, as this may weaken the teat.
Wash your hands thoroughly and ensure surfaces are clean before
contact with sterilised components.
5 After sterilisation, let the soother cool down for 5 minutes and
squeeze out any trapped water from the teat. This is to ensure
hygiene.
To reassemble the soother thermometer:
1 Align the blocks of the measurement unit with the matching slots
in the back of the shield.
 Insert the measurement unit into the shield. Make sure that the tip
of the probe goes into the pocket inside the teat. (Fig. 3)
 Turn the measurement unit 90° clockwise to lock it into position.
Cleaning the flexible-tip thermometer
Do not sterilise or boil the thermometer.