Panasonic PV-M1327 Service Manual page 35

Reassembly Notes
1. Alignment of Wiper Arm Unit and Drive Rack Unit
1) Slide the Drive Rack Unit to the far right as indicated by
the arrow.
2) Install the Wiper Arm Unit so that the hole on the Wiper
Arm Unit is aligned with the hole on the Drive Rack Unit.
Side Plate R
Hole
Hole
Fig. K1-2
2. Installation of Holder Unit
1) Turn the Wiper Arm Unit so that the grooves on each
end are aligned with the grooves on Side Plate L and R.
2) Insert Holder Unit boss (A) and (B) into the grooves.
3) Finally, in the EJECT Position, confirm that the
protrudence on the Wiper Arm Unit is aligned with the
indentation on the Drive Rack Unit.
Side Plate R
Protrudence
Fig. K1-3
3. As an ESD countermeasure, make sure the spring is in
contact with Top Cover.
Drive Rack Unit
Slide
Slot
Wiper Arm Unit
Drive Rack Unit
Indentation
Wiper Arm Unit
Sensor Cover, Opener Lever, and Drive Rack
Unit
Disassembly Procedure
1. Remove the Sensor Cover by releasing Locking Tab (D).
2. Remove the Opener Lever by releasing Locking Tab (E).
Then remove the Drive Rack Unit.
Side Plate R
Locking Tab (E)
2-17
4 Sensor Cover
Locking Tab (D)
5 Opener
Lever
6 Drive Rack Unit
Fig. K2