Panasonic PV-M1327 Service Manual page 10

Service Position
The Basic Service Position does not require the use of Exten-
sion Cables. However, for more extensive servicing, Exten-
sion Cables should be used.
1. Basic Service Position
Service Position
Service Position (1)
Service Position (2)
Service Position (1)
1. Remove Rear Cover, VCR Unit, (Stereo Amp C.B.A.:
Model I), and Top Shield Plate Ass'y.
2. Then, place VCR Unit as shown.
TV Main
C.B.A.
Main
C.B.A.
VCR Unit
Mechanism Chassis
and Cassette Up Ass'y
Fig. 2-1
Purpose
Mechanism check
Mechanical adjustment
Electrical adjustment
Main C.B.A. check
TV Main C.B.A. check
TV
It is not necessary to connect
Degaussing Coil Connector
CAUTION:
HOT CIRCUIT
DO NOT
touch Power
curcuit during service.
CAUTION:
HOT CIRCUIT
C.B.A. and TV Main C.B.A.
Use extreme care to prevent accidental shock when
servicing.
Note:
When disassembling/assembling, refer to "Disassembly/
Assembly Procedures of Cabinet" section.
Service Position (2)
1. Remove Rear Cover, VCR Unit, (Stereo Amp C.B.A.:
Model I), and Top Shield Plate Ass'y.
2. Place VCR Unit as shown.
In order to stabilize VCR Unit, place it on a slanted support,
such as a loose-leaf binder etc.
Insulated material
TV Main C.B.A.
VCR Unit
Main C.B.A.
open
Mechanism
Chassis and
Cassette Up
Ass'y
1-8
(Primary circuit) exists on the Main
It is not necessary to
connect Degaussing
Coil Connector
Stereo Amp C.B.A.
(Model: I)
CAUTION:
HOT CIRCUIT
DO NOT
touch Power
curcuit during service.
Fig. 2-2
TV