Panasonic PV-M1327 Service Manual page 30

T Brake Unit, Changing Lever A, and T Reel
Table
Disassembly Procedure
1. Remove the T Brake Unit while releasing Locking Tab (E)
located under the chassis.
2. Remove Cut Washer (A). Then, pull up on the Changing
Lever A and remove.
3. Pull up on the T Reel Table.
Cut Washer (A)
Locking
Tab (E)
13 Changing
Lever A
Fig. J8-1
Reassembly Notes
1. How to distinguish between S Reel Table and T Reel
Table
S Reel Table
Top View
difference
Fig. J8-2
2. Adjustment of T Reel Table
1) After installing, perform the "Reel Table Height
Adjustment Procedures."
3. Be careful not to lose the Reel Washer under the T Reel
Table.
4. Cut Washer (A) is not reusable. If removed, install a new
one.
12 T Brake
Unit
14 T Reel
Table
Reel Washer
T Reel Table
2-12
Full Erase Head, Tension Arm Unit, S Spring
Arm, and S Reel Table
Disassembly Procedure
1. Turn the Full Erase Head fully counterclockwise as shown.
Then remove it.
2. Unhook Spring (A).
3. Remove the Tension Arm Unit by pulling it up while releasing
2 Locking Tabs (F).
4. Remove the S Spring Arm while releasing Locking Tab (G).
5. Pull up on the S Reel Table.
Spring (A)
15 Full Erase Head
Locking
Tab (G)
turn
Locking
Tabs (F)
"A"
Fig. J9
Reassembly Notes
1. Adjustment of S Reel Table
1) After installing, perform the "Reel Table Height
Adjustment Procedures".
2. Be careful not to lose the Reel Washer under the S Reel
Table.
3. Adjustment of Tension Arm Unit
1) After installing, perform the "Tension Post Adjustment
Procedures."
16 Tension Arm
Unit
17 S Spring Arm
18 S Reel
Table
Reel
Washer
Locking
Tabs (F)
View "A"