Declaration Of Conformity - McCulloch MAC 5616 LITE Instruction Manual

TROUBLESHOOTING TABLE
WARNING:
Always stop unit and disconnect spark plug before performing all of the
recommended remedies below except remedies that require operation of the unit.
TROUBLE CAUSE
1. ON/OFF switch in the
Engine will not
start.
2. Engine flooded.
3. Fuel tank empty.
4. Spark plug not firing.
5. Fuel not reaching
6. Carburetor requires
Engine will
1. Carburetor requires
not idle
properly. 2. Crankshaft seals worn.
3. Compression low.
1. Air filter dirty.
Engine will not
2. Spark plug fouled.
accelerate,
lacks power,
3. Carburetor requires
or dies under
a load.
4. Carbon build-up on
5. Compression low.
Engine
1. Choke partially on.
smokes 2. Fuel mixture incorrect.
excessively.
3. Air filter dirty.
4. Carburetor requires
Engine runs 1. Fuel mixture incorrect.
hot.
2. Spark plug incorrect.
3. Carburetor requires

DECLARATION OF CONFORMITY

EC Declaration of Conformity (Only applies to Europe)
We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46- -36- -146500, as authorised
representative in the Community, declare that the hedge trimmer model McCulloch Mac 5616
Lite with serial numbers dating from 2010 and onwards (the year is clearly stated on the rating
plate, followed by the serial number), comply with the requirements of the COUNCIL'S
DIRECTIVES:
of 17 May 2006 "relating to machinery" 2006/42/EC;
of 15 December 2004 "relating to electromagnetic compatibility" 2004/108/EC, and applicable
supplements; and
of 8 May 2000 "relating to the noise emissions in the environment" in accordance with Annex
V of 2000/14/EC. For information relating to noise emissions, see Technical data section.
The following standards have been applied: EN ISO 12100- - 1/A1:2009, EN ISO
12100- - 2/A1:2009, CISPR 12:2007, EN ISO 10517:2009.
SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, S- -754 50 Uppsala, Sweden, has
performed voluntary type examination on behalf of Husqvarna AB. The certificate(s) are
numbered: SEC/10/2260.
10- -08- -31
OFF position.
carburetor.
adjustment.
adjustment.
adjustment.
muffler outlet screen.
adjustment.
adjustment.
Ronnie E. Goldman, Director of Engineering
Authorized representative for Husqvarna AB and
responsible for technical documentation
REMEDY
1. Move ON/OFF switch to the ON
position.
2. See "Starting a Flooded Engine"
in Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
6. See "Carburetor Adjustment" in
Service and Adjustments Section.
1. See "Carburetor Adjustment" in
Service and Adjustments Section.
2. Contact an authorized service dealer.
3. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug
and regap.
3. See "Carburetor Adjustment" in
Service and Adjustments Section.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
1. Adjust choke.
2. Empty fuel tank and refill with
correct fuel mixture.
3. Clean or replace air filter.
4. See "Carburetor Adjustment" in
Service and Adjustments Section.
1. See "Fueling Engine" in Operation
section.
2. Replace with correct spark plug.
3. See "Carburetor Adjustment" in
Service and Adjustments Section.
-- 9 --