Water Fill (continued)
Notice the water bottles are designed
right and left hand units. Position them in the
correct location so the humidifier can func_
tion properly. The water bottles should rest
in the front of the cabinet. Each "E_Z_Fil!
Side-Cap" must be facing the rear of the
Each water bottle is designed with an "E-Z-
that is easily
Remove the "E-Z-Fiil Side-Cap" on the side
of the water bottle by twisting counterciocb
Place the opening of the water bottle under
a water faucet (the bottle should fit under a
four-inch clearance faucet)• Fill with recom-
mended mixture of cold water and Sears
Bacteriostat #42-14900 (if necessary) only.
Solid debris could make the valve leak•
nnstall the "E-Z-Fill Side-Cap"
Iockwise. Hand tighten only.
;heek for possible
_eaks by performing
• Grasp bottle handle and hold the bottle
upright over a sink.
:. Press up on valve cap plunger for about
one second to let out a little water.
;. Release the plunger.
• Listen for air bubbles.
Look for leaks
around the "E=Z-Fill Side-Cap".
,. If you hear air bubbles or see leaks,
repeat steps 1=4.
Vipe off excess water from the bottle.
_osition the water bottle back into the unit by
irasping the water bottle handle and lower it
_to the cabinet until the bottle sits on pads
t bottom of cabinet The "E-Z=Fi!I Side-Cap"
"lust be facing the rear of the cabinet. When
,ositioned properly, the plunger wil! open
nd water wil! flow into the cabinet. The
,,ater level will automatically
1/2" until the bottles
dlow the filters to saturate for 30 minutes
4ote: Ensure that the raised section of the
,,ater bottle falls into the hole in stationary
d in order for the bottle gauges to function
Should Always Face Rear
to Remove Cap