ATTO Technology ATTO ExpressPCI FC 3300 Technical Specification page 2

Hardware Specifi cations
Fibre Channel Interface:
• 2.125-Gigabit data-transfer rates
• 400 MB/sec. throughput in full-duplex mode
• Auto-negotiation between
2-Gigabit and 1-Gigabit speeds
• Short-Wave Optical LC connector
• Supports all Fibre Channel topologies
• Point-to-Point
• Arbitrated Loop
• Direct Fabric/Switch Attach
• Strict adherence to ANSI FC-AL-2, FC-PLDA
FC-Tape, and FC-FLA specifi cations
• Supports Class 2, Class 3 and Intermix
transfers
• Flash ROM for easy fi eld upgrades
Advanced FC Features:
• Support for SNIA HBA API
• LUN Masking
• Supports Target and Initiator Modes
Advanced SCSI-FCP Support:
• Large command FIFO
• Asynchronous I/O support
• ASPI and SCSI Manager 4.3 compatible
• SCSI-3 tagged command queuing
• Bootable from attached disks
• Support for multiple block sizes
Accelerated PCI Bus Management:
• PCI bus master rate of 528 MB/sec.
• PCI 2.2 compliant
• 64-bit/66 MHz PCI-X (backward compatible
with 32-bit and 33 MHz PCI)
Software Specifi cations
Driver Support:
• Windows® 2000
• Windows XP
• Windows Server 2003
• Solaris (x86 and SPARC)
• Mac® OS X
• Mac OS 9
Advanced Data Streaming (ADS™):
• Improved PCI system bandwidth use
• Optimized FC and SCSI-3 algorithms
• Tagged command queuing
• RISC processor for high performance
RAID kits available
F i b r e
©2004 ATTO Technology, Inc. Specifi cations subject to change without notice.
ATTO ExpressPCI FC 3300
Environmental & Physical
Characteristics
Dimensions:
• Full Form Factor: 4.200" x 6.521"
Operating Environment:
• Temperature: 0-50º C
• Humidity: 10-90% non-condensing
• Airfl ow: 100 LFM (min.)
Power:
• 1 Amp @ 5 Volts
PCI Signal Compatibility:
• 3.3 Volts/5 Volts universal
*Microsoft, Windows, and the Windows logo are trademarks,
or registered trademarks of the Microsoft Corporation in the
United States and/or other countries
Fibre Channel Host Adapter
Selection Chart
C h a n n e l
Confi guration:
• Easy to install connection plate with LED
to monitor on-line and fault status
LED indicates
fault
conditions
*
LED indicates
online status
Optical LC
connector
Rev 09/05