Delta DX-2100 Series User Manual page 67

3. Go back to the DIACom and input the IP address of the router which is connected to your
remote device. Click "Create COM port" to create a virtual tunnel. Once the creation is done,
the virtual IP address will show up on the same page. Users can use this IP address to
connect to your local computer and then you can use the configuring/monitoring software to
configure and monitor the connected device remotely. Click "Delete COM port" to close the
virtual tunnel.
Notice
If the PLC is Siemens S7-200, you can select the "PPI" in the DIACom to support PPI
protocol.
4. Open the WPLSoft to check if the COM parameters are consistent with the settings on your
router. When these parameters are consistent, you can use the WPLSoft to configure/monitor
your device remotely.
C ha pt er 4 I ntr o duc t i on t o DI A Com
4_
4 - 9