Remote Control And Monitoring Via Diacom - Delta DX-2100 Series User Manual

DX - 2 1 00 Ser i es I nd us t r i al 3G C lo u d Ro u ter
_4
4.1.6
4.1.6.1
If your router is connected to remote devices via a LAN port, you can use the
configuring/monitoring software on your local computer to configure and monitor after opening a
virtual tunnel. Some program would require the IP addresses of your remote device. Simply input
the required information in the configuring/monitoring software and then you can configure and
monitor the connected device remotely.
4.1.6.2
After opening a virtual tunnel, you will need to follow the setups below before using WPLSoft or
other configuring/monitoring software on your local computer to configure and monitor the
connected device remotely.
1. Open a browser and input the IP address of the router which is connected to your remote
device on the search bar and then log in.
2. Go to the System setup page, select the setup option RS232 or RS485 and input the required
information to set up. Make sure the parameters are consistent with your remote device.


4 - 8

Remote Control and Monitoring via DIACom

Via a LAN Port
Via a RS232/RS485 Port
Working Mode：Transparent mode
Parameters of COM (Baud Rate, Data Bits, Stop Bits, Parity Bits, Flow Control)