Oki Pacemark PM4410 Setup Manual page 31

Left Tractor (viewed from the back of the printer)
1. Open the tractor cover, place the paper holes over the pins and close
the cover.
2. Fine tune the position of the right tractor to center the paper holes on
the pins of both tractors, then push the right lock lever back.
Finish Up
1. Make sure that the feed stack of paper is directly aligned (left-right)
with its entry point into the tractors: this will promote a smooth flow
of paper into the printer.
2. Close the rear-feed access cover and the back access door.
3. Press FF/LOAD to load the paper into the print path.
The printer is set to a default rear-feed paper width of 13.6
inches (136 columns). If you are using 9-inch paper, you
must enter the printer menu and change the setting to 8
inches (80 columns) to avoid printing on the platen and
Pacemark 4410 Setup Guide E-29