Oki ES3640 MFP Software Installation Manual page 3

Windows TCP/IP
Network Installation (cont'd)
1 Assign an IP address to the MFP
If you are not using DHCP, you need to obtain an IP
Address from your network Administrator and
enter it using the front panel:
1. Confirm that the printer displays [ Ready to
].
print
2. Press ∇ key until [ Admin Setup ] appears. Press
ENTER
.
3. Continue to Setup ? displays. Press
select Yes . The printer goes offline and Running
displays. This will take about a minute.
Setup
4. The Setup Menu displays, press
. Press
Network Setup
5. Press ∇ to select Protocol Setup . Press
6. Press ∇ to select TCP/IP Setup . Press
7. Press ∇ to select Ethernet Setup . Press
8. TCP/IP Ethernet displays. Select Yes and press
ENTER
. Enable AutoIP Config? displays. Select No .
ENTER
Press .
9. The default IP Address displays. Use
change each octet. Press
the next octet or to leave the octet unchanged.
10. Subnet Mask displays. Repeat instructions in
step 9.
11. TCP/IP bound to Ethernet displays. Press
12. Gateway Address displays. Repeat instructions in
step 9.
ENTER
13. Press to exit TCP/IP Setup, Protocol
Setup, and Network Setup.
ENTER
to
∇ to select
ENTER
.
ENTER
ENTER
ENTER
∆ or
ENTER to proceed to
ENTER
14. Select Yes and press
ENTER
Press
15. Printer restarts the server and initializes. Ready
displays.
to Print
.
.
.
∇ to
.
3
ENTER
to Save Changes.
to Exit the Setup Menu.