Hitachi DH 25DL Handling Instructions Manual page 9

6. Do not use the battery for a purpose other than
those specified.
7. If the battery charging fails to complete even
when a specified recharging time has elapsed,
immediately stop further recharging.
8. Do not put or subject the battery to high
temperatures or high pressure such as into a
microwave oven, dryer, or high pressure container.
9. Keep away from fire immediately when leakage
or foul odor are detected.
10. Do not use in a location where strong static
electricity generates.
11. If there is battery leakage, foul odor, heat
generated, discolored or deformed, or in any way
appears abnormal during use, recharging or
storage, immediately remove it from the equipment
or battery charger, and stop use.
CAUTION
1. If liquid leaking from the battery gets into your
eyes, do not rub your eyes and wash them well
with fresh clean water such as tap water and
contact a doctor immediately.
If left untreated, the liquid may cause eye-problems.
SPECIFICATIONS
POWER TOOL
Model
No-load speed Save/Power
Full-load impact rate Save/Power
Concrete
Drilling Steel
Capacity
Wood
Driving Wood screw
Rechargeable battery
Weight
Do not use the "SAVE" mode when boring holes with the wood drill. There is a likelihood that the motor
will burn out.
CHARGER
Model UC36YRSL
Charging voltage 14.4 V – 36 V
Weight
DH25DL
BSL2530:
Li-ion 25.2 V
(3.0 Ah 14 cells)
3.5 kg
UC36YRL
25.2 V – 36 V
0.7 kg 0.9 kg
2. If liquid leaks onto your skin or clothes, wash well
with clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using
the battery for the first time, do not use and return
it to your supplier or vendor.
WARNING
If an electrically conductive foreign object enters the
terminals of the lithium ion battery, a short-circuit may
occur resulting in the risk of fire. Please observe the
following matters when storing the battery.
Do not place electrically conductive cuttings, nails,
steel wire, copper wire or other wire in the storage
case.
Either install the battery in the power tool or
store by securely pressing into the battery cover
until the ventilation holes are concealed to prevent
short-circuits (See Fig. 1).
DH25DAL
0 – 550 min –1 / 0 – 1100 min
0 – 2250 min –1 / 0 – 4500 min
26 mm
13 mm
30 mm
6.2 mm (diameter) × 40 mm (length)
BSL2520B: BSL2530:
Li-ion 25.2 V Li-ion 25.2 V
(2.0 Ah 7 cells) (3.0 Ah 14 cells) (2.6 Ah 20 cells)
3.4 kg 3.6 kg
English
DH36DL DH36DAL
–1
–1
BSL3626: BSL3626:
Li-ion 36 V Li-ion 36 V
(2.6 Ah 20 cells)
3.9 kg 4.0 kg
8