Yamaha EMX7 Owner's Manual page 9

Power amplifier
Portable audio
player
Passive speakers
NOTE
Normally, speakers are connected
via the [SPEAKERS A/B] jacks on
the rear panel. However, if a higher
output level is required, connect the
speakers via a power amplifier that
is connected to the [STEREO OUT]
jack.
6.
Turn on the power.
Switching order:
Instrument or audio device  Mixer [
WARNING
When turning off the power, a loud and unpleasant noise may be generated by
the speakers. To prevent this, first turn off the Mixer [
turn off the instrument or audio device.
7.
Set the [LEVEL] control for the channel that has the connected
t
device to the [ ] position.
8.
Use the STEREO MASTER [LEVEL] control to adjust the overall
sound level.
9.
If necessary, adjust the balance of the connected devices using
the [LEVEL] controls for channels 1 to 11/12.
Optimizing the volume settings
 When the volume is too loud
Turn the [LEVEL] control to the minimum (zero). Set the [
the " LINE" position, and then slowly raise the [LEVEL] control until the desired
volume is reached.
 When the volume is too soft
Turn the [LEVEL] control to the minimum (zero). Set the [
the " MIC" position, and then slowly raise the [LEVEL] control until the desired vol-
ume is reached.
] (Power) switch
] (Power) switch, then
MIC/ LINE] switch to
MIC/ LINE] switch to
Quick Start Guide
9
EMX7 Owner's Manual