Modes Guideline; Heating Up Mode; Operating Mode - JOVY Systems iSolder 40 User Manual

Jovy Systems® Limited

Modes Guideline

Recognize the solder station's status is done by observing the led indicator's color
and state.
When the tip is disconnected from the hand piece, the controller gives a
continuous red light indication on the led indicator.
When the controller is active and sensing, the fast flashing Green Led will be seen
from time to time.
Make sure that the toggle button is upwards (Mode 2) when starting the station;
otherwise the station will enter in the debug mode.

1. Heating up mode

When the tip is fully inserted into the hand piece, the iSolder-40 controller starts
to detect the tip.
The indicator of this state is a flashing green led.

2. Operating mode

When the tip is ready to be used the green led stop flashing and becomes steady
green.
The indicator of this state is a steady green led.
User Manual
Revision
Date
Attention!
UM1501SLD01
1.00
August 2015
Page | 7