Debug Mode - JOVY Systems iSolder 40 User Manual

Jovy Systems® Limited

4. Debug mode

To Enter the Debug mode of the iSolder-40 station, which is also known as the
firmware update mode and is used to update the station to the latest firmware
version, make sure to press the toggle button so that its position is hold
downwards, connect the iSolder-40 station to the PC using the USB port and then
power the station up.
The LED indicator will NOT flash any color
and will remain dim when it enters the
debug mode. When the Station is
successfully connected to the software,
the "Connect" will be available through
the software.
User Manual
Revision
Date
UM1501SLD01
1.00
August 2015
Page | 9