Sleep Mode; Power Saving Mode - JOVY Systems iSolder 40 User Manual

Jovy Systems® Limited
When the upgrade is successfully complete , a message will appear confirming
that the Firmware update process is complete.

5. Sleep mode

When the iSolder-40 controller senses no usage for 5 minutes, the iSolder-40
starts the sleep mode for saving power.
The indicator of this mode is a flashing red led (short on; short off).
To get out from sleep mode and turn to operating mode, move the hand piece
from the holder and wait until the iControl automatically senses and update the
status from Sleep to Operating mode.

6. Power saving mode*

After 15 minutes in the sleep mode, the iSolder-40 will turn to the power saving
mode, where no power is delivered to the tip at all and the tip temperature drops
down to room temperature.
The power saving mode is a safety mode where the device can get out of it by
moving the hand piece to left or right direction.
Also to shift from operating mode switch Off/On the iSolder-40
User Manual
Revision
Date
UM1501SLD01
1.00
August 2015
Page | 11