Philips Norelco S5370CC Manual page 15

ENGLISH
28
C
3 Press the top cap down to open the
SmartClean System.
C
4 Shake off any excess water from shaver
before placing in the SmartClean System.
C
5 Hold the shaver head side down above the
shaver holder with the display facing the
shaver holder.
C
6 Place the shaver into the holder, push
shaver back and press down the top cap to
connect the shaver (click).
The shaver will only fit in the SmartClean System
in one direction.
7 The battery symbol blinks slowly to
indicate shaver is charging.
8 Press the ON/OFF button (
SmartClean System to start the cleaning
cycle.
C
9 The cleaning symbol (
continuously.
◗ The cleaning cycle takes approximately 10
minutes.
◗ Do not press the ON/OFF button while the
cleaning cycle is running. If this does occur, the
cleaning cycle will stop and the cleaning symbol
stops blinking. The cleaning cycle can
be re-started by pressing the ON/OFF button
once.
◗ If the power plug is disconnected before the
cleaning cycle is complete, reconnect the plug
into the outlet and the cleaning cycle can be
re-started by pressing the ON/OFF button
once.
C
NOTE: When the cleaning cartridge filter is full,
the replacement symbol blinks orange. (See
'Replacing the SmartClean System Cartridge').
C
10 When the cleaning cycle is complete and
the shaver is hygienically clean, the ready
symbol lights up continuously.
The battery symbol on the shaver will light up to
indicate the shaver is fully charged.
ENGLISH
29
) on the
) will blink