Philips Norelco S5370CC Manual page 14

ENGLISH
26
◗ Use this appliance for its intended household
use as described in this manual.
C
1 Place the SmartClean System on a flat, level
surface.
To prevent leaking, do not tilt the SmartClean
System.
C
2 While holding the SmartClean System with
one hand, press the button located on the
2
side of the SmartClean System (1) and lift
1
the SmartClean System (2).
C
Remove the seal off the cleaning cartridge.
3
NOTE: ONLY USE PHILIPS NORELCO
SMARTCLEAN CARTRIDGE (MODEL JC302
OR JC303) WITH THE SMARTCLEAN SYSTEM.
◗ When the cleaning cartridge filter is full, the
replacement symbol blinks indicating the
cleaning cartridge should be replaced. See
'Replacing the SmartClean System Cartridge'.
C
4 Place the cleaning cartridge in the
SmartClean System.
C
5 While holding the SmartClean System with
one hand, gently push the top part of the
SmartClean System back down. You will
hear a 'click'.
When the SmartClean System is ready for use,
do not move appliance to prevent leakage.
Cleaning the Shaver in the
SmartClean System
◗ If the shaver does not contain enough power
for one (1) shave, the SmartClean System
may not work properly. Charge the shaver
in the SmartClean System before using the
SmartClean System to clean your shaver.
◗ If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
Connect the small plug to the SmartClean
1
System. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
2. Place the SmartClean System on a flat,
level surface. Make sure the seal has been
removed from the cleaning cartridge (see
'Preparing SmartClean System For Use').
ENGLISH
27