Operating The Hrv Unit Using The Remote Controller Of The Vrv-System Air Conditioner - Daikin VAM 150FAVE Service Manual

SiE71-202
1.3 Operating The HRV Unit Using The Remote Controller of The VRV-System Air
Conditioner
Remote Controller
for VRV
BRC1C51·61
1. Operation lamp
2. Operation/stop button
3. Air flow rate changeover button
4. Ventilation mode changeover button
5. Indication of air flow rate
6. Indication of operation control method
7. Indication of centralized control
8. indication of air filter cleaning
9. Filter signal reset button
10. Inspection button
11. Push the button "
12. Push the button "
13. Push the button "
14. If you press these buttons when using independent operation of the HRV unit, the message "Not
Operation
" and select either one of "
Each time the button is pushed, the indication changes as shown below.
" and set the time.
Each time when " " is pushed, the time advances one hour.
Each time when " " is pushed, the time goes back one hour.
"
Then, the reservation is finished.
Either " " or "
After the reservation is finished, the remaining time is indicated in the display.
For cancelling the timer operation, push the button "
The indication disappears.
Available" will appear on the display for a few seconds.
When the VRV-system air conditioner is connected with the HRV unit with a direct duct, the remote
controller of the air conditioner cannot be used to select the VENTILATION mode. To use the HRV unit
without operating the air conditioner, set the air conditioner in the FAN VENTILATION mode and select
the low fan speed.
"No indication"
" changes from flashing to lighting.
" once again.
" or " ".
Operation
13