Table of Contents
Advertisement
Control Unit technical specifications
- Maximum power soldering iron 50W
- Maximum power desoldering iron 75W
- Power heating unit 900W
- Temperature selection of the soldering part:
200 to 700°F (±5%)
- Temperature selection hot air:
300 to 850°F (±5%)
- Air flow regulation: 6-45 l/min
- Self-contained vacuum pump for holding ICs
- Station's maximum power: 1150W
- ESD protected housing.
Typical surface resistance: 10
square
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- Equipotential connector and the tool tip are
connected to station mains ground supply for
ESD protection.
- Weight of complete unit: 44 lbs
RECOMMENDATIONS FOR USE
For soldering and desoldering
-
Clean the contacts and the printed circuit
to be desoldered of dust or dirt.
-
Preferably select a temperature below
662°F. Excess temperature may cause the
printed circuit tracks to break loose.
-
The tip must be well tinned for good heat
conduction. If it has been inoperative for
any length of time, it should be retinned.
Safety measures
-
Incorrect use of this tool may cause fire.
-
Be cautious when using the tool in places
where inflamable products are stored.
-
Heat can fire up inflamable products even
when they are not at sight.
-
Do not use when the atmosphere is
explosive.
-
Place the tool back on its stand in order to
let it cool down before you store it.
5
11
-10
Ohms/
3
Advertisement
Table of Contents
