Advertisement
SERVICE
Do not attempt to service or repair the equipment yourself. Unplug the unit form the
electrical outlet, and contact an authorized service representative under the following
conditions:
Ø When the power supply cord or plug is damaged or frayed.
Ø If liquid has been spilled into the equipment.
Ø If the electric punch has been exposed to rain or water.
Ø If the unit has been subjected to excessive shock through being dropped or rough
handling.
Ø If the unit does not operate normally when following these Operating Instructions.
§ Adjust only those controls that are specified in these Operating Instructions.
GBC SPECIFICATIONS
Punch Capacity:
Up to 20 sheets of 20 lb. Bond per lift.
Do not punch more than 2 transparent covers at one time. Punching
more than recommended may result in damage to the punch
mechanism.
Binding Capacity: Up to 7/8" (22mm)
Dimensions:
13"W x 7"D x 4.5"H (316mm x 170mm x 109mm)
Weight:
7.8 lbs. (3.5kg) excluding packaging material.
Electrical:
Applicable rating marked on serial plate located on equipment.
115V – 60Hz, 3.1 A
230V – 50/60Hz, 1.5 A
100V – 50/60Hz, 3.5 A
Duty Cycle:
8/15 (On/Off) min.
PUNCHING (FIGURE I)
1. Place the paper in the Punch Throat (A), align the paper fully to the left, and press
the Punch Button (B).
2. Only up to 20 sheets of 20# bond paper should be punched at one time (fewer
sheets if the paper is heavier). Punch covers separately, and only 2-3 covers (no
more than 2 transparent covers) at a time.
3. If you try to punch too much paper, the paper may become jammed in the Punch
Throat. UNPLUG THE MACHINE. Depress the Jam-Stopper knob (C) and
3
Advertisement
