Advertisement
slowly turn it clockwise, while gently pulling on the paper until the paper is
released. Then plug in the machine and press the Punch Button to cycle once.
This will insure that the punching pins return to proper position.
4. Empty the Debris Tray (D) to prevent paper chips from interfering with the punch
operation. The viewing window is conveniently positioned so that you can see
wh4en the Debris Tray is becoming filled and should be emptied.
5. After the entire document is punched, you are now ready to bind.
INSERT (FIGURE II)
1. Choose a VeloBinder® strip set, consisting of a strip with pins and a strip with
slots. If you're using a cover, choose a cover set to color-coordinate with your
VeloBinder® strips.
2. Place your pages between the front and back cover.
3. Put the punched document, face up, onto the table with the punched holes over the
edge of the table. Insert the pins through the punched holes. Turn the document
over and lay flat on the table.
4. Place the slotted strip, with the four open slots facing up, over the four pins.
SNAP (FIGURE III)
1. Hold the VeloBinder® tool with the curved end up, and your forefinger on the
inside of the curve.
2. With your other hand, place a finger on the center of the strip. While holding the
strip firmly on the table, slide the VeloBinder® tool over the pins from the
outside of the right end of the strip to the center, pushing the pins securely into the
slots.
3. Slid the VeloBinder® tool over the pins form the left edge of the strip to the
center. A snapping sound indicates a proper bind.
4. Gently pull the strip and pages in opposite directions so that the binding strip
completely covers the edge of the paper. Your document is now complete!
4
Advertisement
