Honda 2006 RC51 Owner's Manual page 151

Drive Chain
5. Check rear axle alignment by making
sure the chain adjuster index marks ( )
align with the index lines ( ) on both
sides of the swingarm.
Both marks should correspond. If the
axle is misaligned, turn the right or left
drive chain adjusting bolt until the
marks are aligned and recheck chain
slack.
6. Torque the rear axle nut to:
94 lbf·ft (127 N·m , 13.0 kgf·m)
If a torque wrench is not used for this
installation, see your Honda dealer as
soon as possible to verify proper
assembly. Improper assembly may lead
to a loss of braking capacity.
7. Tighten the adjusting bolts lightly by
turning it counterclockwise, then tighten
the lock nuts by holding the adjusting
bolts with a wrench.
144
Servicing Your Honda
4
5
Classic Cycles Technical Resources
8. Recheck drive chain slack (page
Lubrication
Refer to Saf ety Precautions
Lubricate every 500 miles (800 km) or
sooner if chain appears dry. Lubricant:
SAE 80 or 90 gear oil
140 ).
on page 62 .