Changing The Unit Of Measure - Bosch GLM 40 Original Instructions Manual

Deleting the Memory
To delete the contents of the memory, press button 4 [Func] so that symbol
pears on the display. Then briefly press the On/Off button 5 [
played value.
If the measuring tool is switched off during the memory function, the memory value
shown on the display will be deleted.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 27.
To exit addition, press button 4 [Func].
Subtracting Values
To subtract values, press button 3 [–]. The subsequent steps are the same as for
"Adding Values".

Changing the Unit of Measure

Unit of measure "m" (metres) is set by default.
Switch the measuring tool on.
Bosch Power Tools
Press button 6 [+]. The calculated area is shown on the display, and
symbol "+" flashes.
Press the measuring button 2 [
ment. Measure the area as described in section "Area Measure-
ment", see page 27.
Press button 6 [+] to calculate the sum. The end result is shown at
the bottom of the display.
] to delete the dis-
] to start another area measure-
2 609 141 206 | (14.8.14)
English | 29
ap-