Hitachi GP 2S2 Techical Data And Service Manual page 12

(2) Connect the four internal wires of Stator (A) [20] with the parts indicated in Fig. 4.
Connect the internal wires correctly as shown in Fig. 5.
Fig. 4
Connect to the
Brush Holder [30] (Side B)
Connect both the internal wire of the Noise
Suppressor [38] and this wire to Tube (D) [39]
with a solderless connection and connect it to the
Slide Switch [35].
(If the Noise Suppressor [38] is not used,
connect this internal wire to the Slide Switch [35]
after clamping Tube (D) [39] with the solderless
connection.)
Fig. 5
a. Choke coil and Noise Suppressor provided
Connect to the
Brush Holder [30] (Side A)
Side A
b. Noise Suppressor not provided
-9-
Side B