Nt 14/1 Classic; Replace The Electrodes - Kärcher NT 14/1 Service Manual

5.6.2 NT 14/1 Classic

1 Power cord
2 Ferrit ring (anti-interference ring)
3 Power switch
4 Cord grip

Remove the traction relief.

Remove the mains cable from the cable guide.

Pull the mains cable out of the appliance switch.

Install the new mains cable in reverse sequence.

5.7 Replace the electrodes

3
1 Electrodes
2 Connecting cable for electrodes
3 Control chip

Disconnect the connecting cables from the circuit
board and the electrodes.

Replace damaged connecting cables.

Replace the electrodes.

Install new connecting cables in reverse se-
quence.
Note: The connecting cable must be routed as
shown in the illustration within the respective pins.
English 5.906-492.0 Rev. 00 (12/10)
2
2
1
1
11