Scag Power Equipment STWC Operator's Manual page 31

Section 6
To adjust the Custom-Cut Baffle height:
1. Place the cutter deck in the transport position.
2. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck. (See Figure 6.7).
-NOTE-
Hardware location used in the illustrations are
for reference only. Location of hardware may
vary depending on cutter deck size.
MOUNTING
HARDWARE
Figure 6-7. Custom-Cut Baffle
3. Move the Custom-Cut Baffle to desired position.
(See Figures 6.9 through 6.11 for position).
4. Reinstall the mounting hardware as shown. (See
Figures 6.10 though 6.11). Torque hardware to
39ft.lbs.
TOP SET OF HOLES
FOR 3" SETTING
FLATWASHER
Figure 6-8. 3" Custom-Cut Baffle Position
MOUNTING
HARDWARE
2004 CCB
CARRIAGE BOLT
2004 CCB - 3" Setting
ELASTIC STOP
NUT
27
MIDDLE SET OF HOLES
FOR 3-1/2" SETTING
FLATWASHER
Figure 6-9. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
FOR 4" SETTING
FLATWASHER
Figure 6-10. 4" Custom-Cut Baffle Position
CARRIAGE BOLT
2004 CCB - 3-1/2" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 4" Setting
ELASTIC STOP
NUT