Important Safeguards; Electrical Safety; Using / Feeding; Danger Of Scalding - Medela B-Well Instructions For Use Manual

Important Safeguards
lll
When using electrical devices, basic safety precautions should always be followed.
Read all instructions carefully before use.
Product
• Use the product only for its intended use as described in this instruction manual.
• Only use the power cord that comes with the Bottle Warmer.
• Keep appliance dry and do not place in direct sunlight.
• Never immerse the Bottle Warmer in water.
• Only use the Medela components supplied with the unit.
• Check components for wear or damage.
Electrical
• Make sure the voltage of the device is compatible with the power source.
• Plug the power cord into the Bottle Warmer first and then into wall socket.
• Always unplug electrical devices immediately after use.
• Separation from the mains is only assured through the disconnection of the power cord from
the wall socket outlet.
• Keep the power cord away from heated surfaces.
• Never operate an electrical device if it has a damaged power cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
• Do not reach for any electrical device if it has fallen into water. Unplug immediately.
• If the supply cord is damaged, it must be replaced by a new cord set immediately to avoid a
hazard.

Using / Feeding

• This appliance is intended for use by responsible persons, keep out of the reach of children.
• This appliance is not intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure they do not play with the appliance.
• There are no user-serviceable parts inside the Bottle Warmer. Do not attempt to repair the
Bottle Warmer yourself.
• Always use on a flat, stable and heat-resistant surface.
• Whilst pressing the buttons, please hold the Bottle Warmer base to prevent from slipping.
• Always ensure that the correct volume of water has been added before switching on the
Bottle Warmer.
• When in use, the Bottle Warmer contains hot water. Always use and handle the equipment
with care.
• Breastmilk/Babyfood should not be heated for too long.

Danger of scalding!

• Take care when opening the lid after a completed cycle as some residual steam may escape.
• Use a cloth when removing bottles or jars, as they may be hot.
• Use the bottle lift to warm small bottles or baby food jars.
• For hygiene and health reasons, once heated, milk and food should not be reheated and
should be discarded if not used immediately.
• The final temperature of the food and the heating time could vary according to the volume
of food being heated, the initial (room, fridge or freezer) temperature, the consistency of the
food, as well as of the type and material of the feeding bottle or jar.
• Always check milk or food temperature before feeding the baby!
Milk: Shake the bottle or storage container to equalise the milk temperature and check the
temperature by pouring some drops of liquid on the back of your hand.
Food: Stir the food thoroughly and test it yourself before feeding the baby.
EN 7