Bukh DV10 Workshop Manual page 266

R22
1 = Bearing bushing
2 = Measuring gauge
3 = Depth micrometer
Fit the measuring gauge on lower gearbox half.
Calculate the thickness of the intermediate washer G as follows:
Establish measure E as D minus B (thickness of measuring gauge).
Calculate the difference measure F as E minus A (See picture No. 35 on last page).
Calculate intermediate washer G for the input shaft as F plus tightening 0.03 – 0.08 mm.
At the calculations the thickness of the liquid jointing, when compressed, should be included
and an empirical value of 0.02 mm should be considered.
Then fit the necessary intermediate washers in the bearing bores (max. 2 washers per
bore) and heat the bearing bores to about 85°C and fit the roller bearing outer collars with
Loctite No. 601.
009W2229-R01