Table Of Contents; General Description; Setup - Titan 0508074A Owner's Manual

Table of contents

Safety Precautions ........................................................................2-3
Grounding Instructions ..............................................................................3
General Description ........................................................................ 4
Setup ................................................................................................ 4
Operation ......................................................................................... 5
Priming the Pump ........................................................................................5
Painting ............................................................................................................5
Pressure Relief Procedure ..........................................................................7
Spraying Technique ........................................................................ 7
cleanup ............................................................................................ 8
Overnight Storage ........................................................................................8
Long Term Storage .................................................................................. 8-9
Maintenance .................................................................................. 10
Removing and Cleaning the Inlet Valve .............................................10
Removing and Cleaning the Outlet Valve .........................................10
Troubleshooting ............................................................................ 11
Parts List ......................................................................................... 32
warranty ........................................................................................ 39

General Description

This fine finish spray system is versatile enough to use for low
pressure fine finish work as well as high pressure airless spraying. The
system includes a diaphragm paint pump and an air compressor that
work together to provide this versatility.
Material Pressure
Gauge
PRIME/SPRAY
Valve

Setup

Use this procedure to set up the spray system.
1. Make sure the pump ON/OFF switch and the compressor ON/
OFF switch are in the OFF position.
Compressor
ON/OFF
Switch
Pressure Control Knob
2. Make sure the pressure control knob is turned fully
counterclockwise to its lowest pressure setting.
3. Lock the gun by flipping the trigger lock into lock position
(see spray gun manual).
English
Air Pressure
Regulator
Air Compressor
Air Outlet
Fitting
Air
Pressure
Gauge
Material
Outlet Fitting
Diaphragm Pump
Pump ON/OFF
Switch
4. Using a wrench, attach a minimum of 50' of 1/4" nylon airless
spray hose to the material outlet fitting on the pump. Tighten
securely.
5. Attach the spray hose to the material inlet fitting on the spray
gun. Using two wrenches (one on the gun and one on the
hose), tighten securely.
Standard Hose
Con guration:
Air Inlet
Fitting
Coupling
Air Hose
With Optional
Whip Hoses:
Air Whip
Air Hose
Material Hose
Make sure all airless hoses and spray guns are
electrically grounded and rated for at least 2800 PSI
(19 MPa) fluid pressure.
6. Attach the air hose to the air outlet fitting on the compressor.
Tighten securely.
7. Attach the air hose coupling to the air inlet fitting on the spray
gun. Attach the air hose to the coupling. Tighten securely.
reversing the hose connections could result in serious
injury. Make sure the airless spray hose is connected
from the diaphragm pump to the material inlet fitting
on the gun and the air hose is connected from the
compressor to the air inlet fitting on the gun.
8. Make sure the electrical service is 120V, 15 amp minimum.
9. Plug the power cord into a properly grounded outlet at least
25' from the spray area.
IMPOrTaNT: always use a minimum 12 gauge, three-wire
extension cord with a grounded plug. Never remove the third
prong or use an adapter.
4
Material
Inlet
Fitting
Material
Hose
Air Inlet
Fitting
Material
Inlet
Coupling
Fitting
Material
Hose
Whip Hose
Straps
© Titan Tool. All rights reserved.