Wall Mounting - Panasonic KX-TES824 Installation Manual

2.2.7

Wall Mounting

The PBX is designed for wall mounting only. The wall where the PBX is to be mounted must be able
to support the weight of the PBX. When wall mounting the main unit, use either the included screws,
or screws of the same size.
Mounting on a Wooden Wall
The included screws may be used when mounting the main unit on a wooden wall.
1.
Place the template (found on the last page of this manual) on the wall to mark the 3 screw
positions.
Template
Note
When you print out the template, the distance on the paper output may deviate slightly from the
indicated measurement. In this case, use the indicated measurement.
2.
Fit the washers on the screws, and drive the screws into the wall.
Washer
Drive the screw
to this point.
3.
Affix the PBX to the screw heads.
Notes
• Do not block the openings of the cabinet. Leave at least 20 cm of space above and 10 cm
to the sides of the PBX for ventilation.
• Make sure that the wall behind the cabinet is flat and free of obstacles, so that the openings
on the back of the cabinet will not be blocked.
2.2 Installing the Advanced Hybrid System
Installation Manual 33