Table of Contents
Advertisement
iCharger Synchronous Balance Charger/Discharger
NiMH/NiCd Battery Charge Advanced Setup
Click "
" to enter NiMH/NiCd Battery CHARGE OPTION SETUP interface, after setting click "
return to the previous interface.
Note: For the over-discharged NiMH/NiCd battery, the voltage may be close to 0V, tick Allow 0V
Charging to allow charge with 0V.
Tick Trickle Enable→Enable to activate trickle charge and set the parameters, after setting click"
previous interface.
Note: Tick Enable to activate trickle charge.
Trickle charge means when the standard charge is completed, the charger will charge the
battery with the setting trickle current until the setting trickle timeout, then to stop the
charging process.
NiMH/NiCd Battery Charge Safety Setup
Click "
" to enter CHARGE SAFETY SETU interface, see details about setting on Page19 LiPo/LiIo/LiFe Battery
Charge Safety Setup.
NiMH/NiCd Battery Discharge Setup
Select Program→Discharge to enter Discharge setup interface.
Note: 1. Regenerative mode has three modes available: OFF, To input, To channel. See more details on
Page37
Important
2. To channel Setup please see Page20
NiMH/NiCd Battery Discharge Safety Setup
Click "
" to enter DISCHARGE SAFETY SETUP interface, see details about setting on Page19
Battery Charge Safety
Setup.
Notes.
To channel
- 22 -
Sensitivity:
1mV-20mV; default: 3mV
Delay time:
0Min-20Min; default: 3Min
Trickle current:
0.02A-1A; default: 0.05A
Trickle timeout:
1Min-999Min; default: 5Min
Discharge Current:
0.05A-40A; default: 2A
Discharge Voltage:
0.1V-40V; default: 0.1V
End Current:
1%-100%; default: 50%
Regenerative Mode:
OFF (default), To input, To channel
Setup.
4010DUO
" to
" to return to the
LiPo/LiIo/LiFe
Hide quick links:
Advertisement
Table of Contents
