Installing The Printer - Epson TM-L90 User Manual

English
WARNING:
If an accident occurs when the power
switch cover (shown to the right) is
attached, immediately remove the
bottom cover and unplug the power
supply cable to avoid a fire hazard.
Unpacking
The following items are included for the
standard specification printer. If any items are damaged, contact your dealer.
❏
Printer
❏
Label roll paper
❏
Power switch cover
❏
Roll paper spacer
❏
Screw for installation of roll paper spacer
❏
Cover operation label
Downloading Drivers, Utilities, and Manuals
Drivers, utilities, and manuals can be downloaded from one of the following
URLs.
For customers in North America, go to the following web site:
http://www.epsonexpert.com/ and follow the on-screen instructions.
For customers in other countries, go to the following web site:
http://www.epson-pos.com/

Installing the Printer

Whether you are going to use the printer in the label peeler issuing mode or label
continuous issuing mode (not using the peeler), you must install this printer
vertically (with the paper exit at the front). See the illustration at the top of page 5.
You can install it either on a flat surface, or you can hang it on a wall by using the
optional bracket (WH-10).
If the paper exit is blocked by label backing paper accumulating on a table or other
surface, a paper jam or other problem may occur. Install the printer in a location,
such as at the edge of a counter, where the backing paper will not accumulate near
the paper exit.
4 TM-L90 with Peeler User's Manual