Sharp LC-32GD8EE Service Manual page 25

VCTp Software Updating, HyperTerminal (continued)
2. Send the command "DWMD" to enter TV set in Download Mode. The TV set answer sending same symbol con-
tinuosly. If this symbol character doesn't appear, please don't worry and pass to next step.
3. Close this connection and open "P55_115200bps"
you can find in "START\All programs\Accessories\ Communications\HyperTerminal\HyperTerminal" folder.
4. Using "Transfer\Send fi le..." menu, select desired fi le (.bin format) and the transmission protocol (Xmodem) as
show below.
5. After press "Send" button the updating process starts as follows:
6. When fl ash update process fi nishes, the " Flash programming complete " label appear in the screen , the device
automatically go to switch off, and in a few seconds go to switch on again.
VERY IMPORTANT NOTE:
During the updating time, please don't use the PC for other purpouses, in order to abolish communication
problems between TV set and PC. If TV set was not updated properly, the TV won't have the software to startup
again, and you must follow the "I2C method" to update another time the TV set.
connection clicking over the "P55_115200bps"
(*)
27
25
LC-26GA5E
LC-32/37GD8E/RU
LC-32GA5E
LC-26P55E
LC-32/37BT8E/RU
LC-26GA5E
LC-32P55E
LC-32GA5E
LC-37P55E
that
(*)