Table of Contents
Advertisement
Set Monitor Out
Setup
Menu Preference
Screen Saver
Set The Inputs
Set Black Side Panel
Set Closed Captions
Set Monitor Out
Move
Monitor- Select Monitor to output the audio and video signals of the chosen input source (ANT A, ANT B, VID1-VID5) to a VCR or other
A/V device.
TV Tuner Out- Select TV Tuner Out to output the audio and video signals of the last watched Antenna Source (ANT A, ANT B).
Use CURSOR PAD
Press EXIT to quit menu or select SET MONITOR OUT to return to the previous menu.
CableCARD Info
Setup
CableCARD Info.
Set AV Control
Upgrades
Set Stand-By Mode
Move
Use the CURSOR PADS and the SELECT button to access the CableCARD INFO.
Press EXIT to quit menu or select CableCARD INFO to return to the previous menu.
This feature will not be available (grayed out) if the CableCARD is not installed properly.
NOTE:
Set AV Control
Setup
CableCARD Info.
Set AV Control
Upgrades
Set Stand-By Mode
Move
Use the CURSOR PADS and the SELECT button to check the Connected RS232C box.
Press EXIT to quit menu or select SET AV CONTROL to return to the previous menu.
For use with third party home Audio/Video control systems which are commercially available. Please see your dealer
NOTE:
regarding these "non Hitachi" home control systems.
Downloaded from
www.Manualslib.com
This feature will select the source of the Monitor Output.
Select
SEL
and
to highlight the function to change then press the SELECT button to select the function.
Select this feature to access your CableCARD ID and HOST ID. Please have this information ready when
you call your cable operator (see also page 13).
Select
SEL
This feature will select the AV Control feature. Set this feature if you want to control some of the TV functions
from an external home control system.
Select
SEL
manuals search engine
Setup
Set Monitor Out
Video Out
Monitor
TV Tuner Out
Move
Return
SEL
or
Setup
CableCARD Info.
Select the button below to access
your CableCARD ID and Host ID.
CableCARD Info
or
Move
SEL
Select
Setup
Set AV Control
If you want to use the AV Control
function, please set the RS232C.
Connected RS232C
or
Move
Return
SEL
80
SETUP
Advertisement
Table of Contents
