Table of Contents
Advertisement
AV NETWORK SETUP WIZARD
SETUP PROCEDURE USING AV NETWORK DEVICE CODES:
An AV Receiver Setup example is shown below. If your device is not listed or the device codes not work after following the setup
procedure, please refer to the AV NET Learning wizard procedure on pages 33-35.
1.
Press the A/V Net button on the remote control.
2.
Use CURSOR PADS
3.
Press the SELECT button or CURSOR PADS
remote control and the device selection screen appears.
4.
Use the CURSOR PADS
and press the SELECT button on the remote control.
5.
The Setup button on the bottom of the screen becomes
highlighted. Press the SELECT button on the remote control
to enter the setup screen.
6.
Using the remote, enter the four digit Device Code for your
equipment, found on page 26.
7.
Use the CURSOR PAD
CURSOR PADS
device is connected.
8.
Use the CURSOR PAD
CURSOR PAD
ON,
OFF or TV as Center.
9.
Press CURSOR PAD
the CURSOR PADS
softkeys, before pressing the SELECT button to perform a
Transmission Test of the softkey selected. If the device
responds, then it is properly set up. Select OK. (If the
Transmission Test failed, try another code.)
Downloaded from
www.Manualslib.com
and
to highlight Device Setup.
and
to choose AV Receiver
to select AV Input. Press the
and
to set the INPUT to which your
to select Internal Speakers. Press
and
to set the Internal Speakers to
to select Transmission Test. Press
,
to select Power, Play, or CH UP
manuals search engine
10. If "OK" was selected, and the 4 digit code was invalid, the
screen below appears, then goes back to the Device
Code
on the
11. Repeat Device Setup procedure until the Source (SRC)
Setting Screen appears.
This screen allows you to assign a label for each Source (SRC1
to SRC8) connection on the AV Receiver. Depending on the
number of source connections to the AV Receiver, some sources
may not be available.
12. To label your sources, use CURSOR PAD
highlight SRC1.
13. Use CURSOR PAD
DVD2, VCR, VCR2, PVR, CBL, STB, TV or Custom). If
SRC1 is active, video and audio will be available depending
on the connections.
14. Repeat for SRC2 to SRC8 if applicable.
15. Select DONE to continue.
16. Select CONTINUE to setup another device.
17. Select DONE to finish and the screen below appears to
show the device(s) which has been set-up.
18. Select EXIT to quit.
25
entry screen.
and
to select the Source (DVD,
and
to
Advertisement
Table of Contents
