Table of Contents
Advertisement
AV NET LEARNING WIZARD
This function of the AV NET makes it more expandable because it allows the user to use equipment that is not supported by the AV
NET Codes. For example, after programming your equipment to the AV NET and the soft keys do not work, the user just has to
follow the steps below. The AV NET Learning Wizard will transfer any remote button IR code of your equipment to the soft keys of
your AV NET. If all remote button transfers are successful, the user can now control their equipment by using the LCD Television
remote control.
A Custom VCR Setup example is shown below. Setup of Custom DVD3, PVR2, CBL2 and STB2 follows the same procedure.
1. Press A/V NET button on the remote control.
2. Use the CURSOR PAD
press the SELECT button or CURSOR PAD
3. Use the CURSOR PAD/SELECT button to choose CUSTOM
option (Ex. VCR3).
4. Use the CURSOR PAD to select Setup, press the SELECT
Please choose the device to set up.
( ) DVD
( ) DVD2
( ) VCR
( ) VCR2
( ) AV Receiver
( ) PV Recorder
( ) Cable Box
BACK
SETUP
Move
Next Step
SEL
5. Select the preferred TV Softkeys (Ex.
press the SELECT button.
HITACHI AV NET WIZARD (Learning)
Select the VCR3 softkey to learn?
TV Softkeys
POWER
CH
BACK
Move
SEL
6. Press and hold the
while pointing directly at the learning AV NET sensor of the
LCD Television (located behind the screen) at a
distance of 2 to 3 meters or 5 to 10 feet.
HITACHI AV NET WIZARD (Learning)
Press and hold desired button to
transfer the command to AV NET.
Please wait while AV NET
Learns the command...
7. If the code is not accepted, the screen below appears.
HITACHI AV NET WIZARD (Learning)
Transfer not completed!
Try again?
NO
YES
Move
SEL
8. If the code transfer was succesful, the screen below appears.
9. Select OK to continue.
HITACHI AV NET WIZARD (Learning)
Transfer was successfull
Press OK to continue.
BACK
OK
Move
SEL
Downloaded from
www.Manualslib.com
and
to select DEVICE SETUP,
( ) Set Top Box
( ) DVD3 (Custom)
( ) VCR3 (Custom)
( ) PVR2 (Custom)
( ) CBL2 (Custom)
( ) STB2 (Custom)
List
MODIFY
button)to learn,
CH
TV/VCR
MENU
SELECT
EXIT
Select
button of the VCR remote control
Select
Select
manuals search engine
10. A check mark appears next to the programmed softkey.
Select DONE to EXIT or CONTINUE to learn another softkey.
.
11. Use the CURSOR PAD
CURSOR PADS
device
12. Repeat step 11 for Audio Input. If the DVD is connected to
the TV, select "Using TV". If the DVD is connected to an
external amplifier, select "no connection".
13. Press CURSOR PAD
a Transmission Test by selecting Power, Play, or CH UP
softkeys. If the device responds, then it is properly set up.
Select OK.
14. Press Done.
15. Press Exit to Quit.
34
HOW TO USE THE REMOTE
TO CONTROL YOUR LCD TV
to select Video Input. Press the
,
to set the INPUT to which your
is connected.
to select Transmission Test. Perform
Advertisement
Table of Contents
