Installing The Optional Internal Dual Sd Module; Network Daughter Card; Removing The Network Daughter Card - Dell PowerEdge R730 Owner's Manual

Convention
C
D
E
Next steps
Follow the procedure listed in

Installing the optional internal dual SD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
Steps
1. Locate the Internal Dual SD Module (IDSDM) connector on the system board. To locate the internal
dual SD module connector, see
2. Align the IDSDM with the connector on the system board.
3. Push the IDSDM until it is firmly seated on the system board.
Next steps
1. Install the SD card(s).
NOTE: Temporarily label each SD card with its corresponding slot before removal. Replace the
SD card(s) into the same slots.
2. Follow the procedure listed in

Network daughter card

Removing the network daughter card

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. If installed, remove expansion card(s) from the expansion card riser 2.
4. Keep the #1 Phillips screwdriver handy.
100
IDSDM indicator code
Flashing amber
Amber
Not lit
After working inside your
Safety instructions.
Before working inside your
System board jumpers and
After working inside your
Safety instructions.
Before working inside your
Description
Indicates card mismatch or that the card has
failed.
Indicates that the card is offline, has failed, or is
write protected.
Indicates that the card is missing or is booting.
system.
system.
connectors.
system.
system.