Table of Contents
Advertisement
Other Configuration
Overview
In most cases, the configuration covered in this chapter is not necessary. If
required, chapter 2 will direct you to this chapter.
DHCP
A DHCP (Dynamic Host Configuration Protocol) server provides an IP address and
related data to a DHCP client (PC or device) upon request.
Existing DHCP Server
If using an existing DHCP Server:
•
Configure it to provide the ISDN Router's IP Address as the Default Gateway.
•
The DHCP Server in the Level One ISDN Router should be disabled. This
setting is on the LAN tab.
ISDN Router's DHCP Server
Normally, the default values do not need to be changed. However, if your LAN
already has some devices using fixed IP Addresses, you need to set the IP Address
range used by the DHCP Server to be compatible.
•
The ISDN Router's IP Address must be within the address range you wish to
use. This should have been set during initial configuration.
•
DHCP Server settings (below) are on the LAN tab of the Manager utility.
Enable/Disable
Start IP Address
Finish IP Address
DNS IP Address
Enable/Disable the DHCP Server.
Sets the addresses allocated to DHCP clients by the
DHCP server.
This also sets the number of DHCP clients -
maximum is 253.
If multiple entries are provided, the first available
DNS will be used.
3
13
Advertisement
Table of Contents
