User Interface - Fritz! 300E Installation And Operation Manual

User Interface

The FRITZ!WLAN Repeater has a user interface. In the user interface you can confi gure
the FRITZ!WLAN Repeater using a Wizard, enable functions and view information about
connections.
The user interface can be opened on every computer connected with the
FRITZ!WLAN Repeater or your wireless LAN base station:
1. Open a web browser.
fritz.repeater
2. Enter in the address fi eld.
3. The user interface opens.
Web browser: opening the user interface with fritz.repeater
26
LEDs
The LEDs show the operating status of the FRITZ!WLAN Repeater:
LED Condition Meaning
fl ashing No connection with wireless LAN base station or searching for
WLAN base station.
LEDs on The more LEDs are lit up, the stronger the signal of the
wireless connection between the base station and the
FRITZ!WLAN Repeater.
Power fl ashing • The FRITZ!WLAN Repeater is being restarted.
• The fi rmware is being updated.
on The FRITZ!WLAN Repeater is ready for operation.
WLAN fl ashing • Adopting the WLAN settings.
• Switching the radio network on or off .
• Performing WPS.
fl ashing The WPS procedure was aborted: More than two wireless
rapidly devices are performing WPS at the same time. Repeat the
procedure.
on The wireless LAN module is ready for operation.
LAN on A network connection is active to a connected device (net-
work adapter, hub or switch).
All fl ashing The FRITZ!WLAN Repeater is reset to its factory settings.
27