NetComm T1 User Manual page 26

Advanced
This page allows you to modify the advanced wireless settings for your 3G Router. These settings should not be changed unless you are
aware of what effect they will have.
Name
Beacon Interval:
Data Beacon Rate (DTIM):
Fragment Threshold:
RTS Threshold:
AP Isolation:
TX Power:
WMM Capable:
WMM Parameters:
Broadcast Network Name (SSID):
Click Apply to save the settings.
3G Travel Router t1 User Guide
26
Description
Interval of time the wireless router broadcasts a beacon, used to synchronize the wireless network.
Enter a value between 1 and 255 for the Delivery Traffic Indication Message (DTIM). A DTIM is a countdown informing clients of the
next window for listening to broadcast and multicast messages
This specifies the maximum size of a packet during the fragmentation of data to be transmitted. If you set this value too low, it will
result in bad performance.
When the packet size is smaller than the RTS threshold, the wireless router will not use the RTS/CTS mechanism to send this packet.
This feature allows you to isolate clients on your wireless network. To enable communication between the wireless clients connected
to your 3G Router, select Disabled. To cut the communication between the wireless clients, please choose Enabled.
This determines the output power of the antenna
WMM (Wi-Fi Multimedia) if enabled supports QoS (Quality of Service) for experiencing better audio, video and voice in applications
Click on the WMM Configuration button to configure the WMM parameters
Select 'Disabled' to hide the SSID of your 3G Router. If disabled, other people will not be able scan and detect this product's SSID.
YMLT1WN
www.netcomm.com.au