Advanced Operation - Jacob Jensen Telephone 50 User Manual

h .1 . Setting ringer Volume & ringer type
Ringer Volume
Key Map:
Audio Setting
select the volume
1. To arrive at this menu, push
use / to start browsing until "Audio Setting"
is shown on the screen. Press
2. Press / to select "Ringer Volume" and press
3. Press / to select the volume you want. (you
will hear a sample of each as you scroll through), then
press to confirm.
4. Press to exit and return to standby. If you select
Volume "Off", will be displayed.
Ringer Type
Key Map:
Audio Setting
select the option
1. To arrive at this menu, push
use / to start browsing until "Audio Setting"
is shown on the screen. Press
2. Press / to select "Ringer Type" and press
3. Press / to select the "External", "Internal",
"Paging", "Alarm", or "Appointment" and press
confirm.
4. Press / to select the melody you want. (you
will hear a sample of each as you scroll through), then
press to confirm your selection.
5. Press to exit and return to standby.
h .2 . Appointment
Key Map:
time & Alarm
your appointment
The date and time must be set before you can access the
Calendar menu option. To set date and time, see section
d .3 . Setting date/time. Your phone allows you to set five
personalized date and time appointments.
1. Press to access the main menu.
2. Press / to select "Time & Alarm". Press
ringer Volume
in standby mode, and
ringer type
select the ringer type
in standby mode, and
Set Appointm . – Select
3. Press /
4. Press /
to "Appointment 5". Press
5. Press /
6. Enter date and time for the appointment. Refer to d .3 .
Setting date/time. Press
7. Enter the appointment name using the keypad (up to 13
characters). Press
i .

AdVAnCEd opErAtion

Special Attention!!
the following sections are only for users who are familiar
with electronics products . failure in following steps correctly
may stop your dECt phone from normal operation .
i .1 . to register a cordless handset
When you register a cordless handset to your base, you will
be asked to enter your base PIN code. To enable registration
mode on the base unit, press and hold the PAGE button for
five seconds. The LED on the base will flash one time when
registration mode is enabled. Before registration, make sure
the new handset is fully charged and that you have the base
and the handset in front of you. Also, make sure that all
handsets and the base are in standby.
On the handset you want to register:
Key Map:
to Add . Settings
the base number
1. Press to access the main menu.
2. Press /
3. Press /
to confirm.
4. Press /
to confirm.
If the base already has the maximum number of six handsets
registered, you will need to deregister one of the existing
handsets before you can register the new handset. See
section i .2 . deregister a handset or a base.
to select "Set Appointm.". Press
to select one from "Appointment 1"
to select "On". Press
register
to select "Add. Settings" and press
to display "Register" and press
to select your base number and press
select
19