Nortel Remote Gateway 50 Configuration Manual page 112

Page 112 of 258
553-3001-207 Standard 2.00
Bandwidth Management
5 Provision the main office with the DGT table DMIs to insert the prefixes
and set the Type of Number correctly. Create RLB RLI entries to use
these DMIs for the VTRK route(s). One RLI per branch office will be the
minimum requirement. Note that calls from remote systems will typically
have the HLOC prefix, so this is defined here
Table 8 lists main office B DMI and RLI provisioning.
Table 8
Main office B DMI and RLI provisioning (for calls in branch office B)
Create a DMI
LD 86
REQ new
CUST 0
FEAT dgt
DMI 50
DEL 0
ISPN no
INST 741841
CTYP loc
6 Provision the main office with CDP DSCs (mapped by the RLI into
Location Codes) sufficient to uniquely identify all of its branch offices
(using extended location codes, if required); use the RLI index defined for
each branch office as the RLI value of the LOC definition. This is the route
to the branch office.
January 2006
Create an RLI
LD 86
REQ new
CUST 0
FEAT rlb
RLI 50
ENTR 0
LTER no
ROUT 71
DMI 50