Notice Page Printed - Sharp AR-5127 Series Printer Operation Manual

NOTICE PAGE PRINTED

If you find that a notice page has been printed at the end
of a print job, the print data received from the computer
has not been printed as specified. Fix the problem as
explained below and then try printing again.
If a NOTICE PAGE is printed
If the following NOTICE PAGE is printed, check your
settings for the Staple function.
****************************************************
Notice Page
****************************************************
The IMC memory full error had occurred,
a normal output was not able to be executed.
Please refer to the operation manual for
the solution method.
When the Staple function is selected:
Either set the print quality to 'Draft', or select a larger
number for "MEM. FOR PRINTER" in the "COPY" -
"FUNCTION SETTING" key operator program. If this
still does not solve the problem, increase the IMC
memory.
CONTENTS
When the Staple function is not selected:
Turn off the ROPM function setting. If you wish to use
the ROPM function, set the print quality to 'Draft' or
increase memory.
NOTE:
The IMC memory is used to store print data when the
ROPM function is used. This memory is also used to
store original image data in the copy mode. The
percentage of the memory used for the printer feature
can be adjusted using a copier key operator program.
See the key operator's guide in the operation manual.
The memory can be extended by adding commercially
available memory modules. For details, contact your
SHARP dealer.
Disabling notice page printing
Notice page printing can be disabled using a key
operator program.
INDEX TOP OF CHAPTER
KEY OPERATOR PROGRAMS
TROUBLESHOOTING
23 23